After completing the first scarf (light green rayon weft yarn), I left a 5cm gap and hemstitched with light blue rayon yarn in order to weave the second scarf on this warp.
After hemstitching, I began to weave. I began at the highest reed position and wove 10 picks. At the first Yellow/White/Yellow, I added my logo in cream (zinger colour) supplementary weft yarn. I then wove 6 picks per position band with 12 picks at the turning points for 4 down/up cycles of the reed – however, I only wove at every second vertical position band ie Blue/Yellow/White/Yellow/Blue until I had 191cm of woven fabric. I ended at the low blue vertical reed position and hemstitched there.



I decided that I would like a sample of this woven fabric in order to recall accurately the effects of the adjacent half-fans with and without the zinger at the centre of the half fan. So I then left a gap before hemstitching at the low blue reed position and continuing to weave. I decided to try something new for the vertical movement of the reed in this small sample. I wove at the low blue position until there was no further warp movement ie the warp matched the width of the fan reed at that position, then I moved the reed to the highest position that I could weave at with the aim to weave at the highest blue reed position until the warp matched the width of the fans at that point. After that, I moved the reed to the lowest position and repeated this movement until I could weave no further and hemstitched. It was not possible to move the reed entirely from the lowest to the highest position in a single motion, it took a few picks at intervening positions to allow the warp to undulate sufficiently to reach the highest or lowest position.
The fabric was then removed from the loom, the three pieces cut apart with a rotary cutter and fringes re-trimmed if necessary. I then measured all the pieces, wet-finished them, trimmed loose ends and hung them to dry. I did not press them as I wanted to retain the bubbling created by the warp undulations. Once dry, I re-measured and weighed the pieces.
Both scarves show a large amount of iridescence, this is best seen with the green weft. The red warp/green weft is just amazing – the fabric almost appears gold!
The position on the warp where I begun to use the weighted pegs to help keep the selvedges straight was marked with a piece of blue yarn. I checked for differences before and after the marker yarn and was unable to find any. I did find it easier to manage the weaving with the weighted selvedges as it gave me one less thing to think about while managing everything that happens in weaving a single pick.
The supplementary weft logos came out very well, BUT they are both mirror images of my intention. I will amend the pattern for the logo so that next time I use it the logo will be in the correct orientation.




| Pre-wash | Post-wash | Weight | |
| Green weft | 44cm x 195cm | 44cm x 184cm | 114g |
| Blue weft | 42cm x 189.5cm | 41cm x 181cm | 97g |
| Sample | 44cm x 10.5cm | 43cm x 10cm | 6g |